Fujitsu SPARC T5440 Manual do Utilizador descarregar pdf (Página 59)

Managing Faults 33

■ Environmental or configuration faults – System configuration faults. Or

temperature or voltage problems that might be caused by faulty FRUs (power

supplies, fans, or blower), or by room temperature or blocked air flow to the

server.

■ POST-detected faults – Faults on devices detected by the POST diagnostics.

■ PSH-detected faults – Faults detected by the Solaris Predictive Self-Healing (PSH)

technology.

■ External I/O Expansion Unit faults – Faults detected in the optional External I/O

Expansion Unit.

Use the show faulty command for the following reasons:

■ To see if any faults have been diagnosed in the system.

■ To verify that the replacement of a FRU has cleared the fault and not generated

any additional faults.

Related Information

■ “Diagnostic Flowchart” on page 11

■ “Detecting Faults Using LEDs” on page 30

■ “ILOM-to-ALOM CMT Command Reference” on page 53

■ SPARC Enterprise T5440 Server Installation and Setup Guide

■ SPARC Enterprise T5440 Server Administration Guide

■ Integrated Lights Out Manager 3.0 Supplement for SPARC Enterprise T5440 Server

▼ Detect Faults Using the ILOM show faulty

Command

● At the -> prompt, type the show faulty command.

The following show faulty command examples show the different kinds of

output from the show faulty command:

■ Example of the show faulty command when no faults are present:

-> show faulty

Target | Property | Value

--------------------+------------------------+-------------------------------

-----------------------------------------------------------------------------

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 213 214

Sem comentários

Fujitsu SPARC T5440 Manual do Utilizador Página 59