Fujitsu SPARC T5440 Manual do Utilizador descarregar pdf (Página 135)

Servicing Customer-Replaceable Units 109

■ If the show faulty command does not report a fault with a UUID, then you

do not need to proceed with the following step because the fault is cleared.

6. Run the set command.

▼ Add FB-DIMMs

If you are upgrading the system with additional FB-DIMMs, use this procedure.

Before you begin, complete these tasks:

■ Read the section, “Safety Information” on page 59.

■ Read the sections, “Supported FB-DIMM Configurations” on page 110 and

“FB-DIMM Device Identifiers” on page 112.

■ Power off the server using one of the methods described in the section, “Powering

Off the System” on page 63.

■ “Extend the Server to the Maintenance Position” on page 66

■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 69

■ “Remove the Top Cover” on page 69

■ “Remove a CMP/Memory Module” on page 99

1. Unpackage the FB-DIMMs and place them on an antistatic mat.

2. Ensure that the ejector tabs are in the open position.

3. Line up the FB-DIMM with the connector.

Align the FB-DIMM notch with the key in the connector. This ensures that the

FB-DIMM is oriented correctly.

/SP/faultmgmt/0 | timestamp | Dec 14 22:43:59

/SP/faultmgmt/0/ | sunw-msg-id | SUN4V-8000-DX

faults/0 | |

/SP/faultmgmt/0/ | uuid | 3aa7c854-9667-e176-efe5-e487e520

faults/0 | | 7a8a

/SP/faultmgmt/0/ | timestamp | Dec 14 22:43:59

faults/0 | |

-> set /SYS/MB/CPU0/CMP0/BR0/CH1/D0 clear_fault_action=True

Are you sure you want to clear /SYS/MB/CPU0/CMP0/BR0/CH1/D0 (y/n)? y

Set ’clear_fault_action’ to ’true

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 213 214

Sem comentários

Fujitsu SPARC T5440 Manual do Utilizador Página 135