Fujitsu SPARC T5120 Manual do Utilizador descarregar pdf (Página 96)

70 SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009

If either of these conditions exist, you must power off the server before replacing a

hard drive.

Related Information

■ “Removing Power From the System” on page 60

■ “Power Off the Server (Service Processor Command)” on page 60

■ “Power Off the Server (Power Button - Graceful)” on page 62

■ “Four-Drive Capable Backplane Configuration Reference” on page 77

■ “Eight-Drive Capable Backplane Configuration Reference” on page 78

■ “Sixteen-Drive Capable Backplane Configuration Reference” on page 79

Hard Drive LEDs

Each hard drive has a group of three status LEDs, as shown in the following figure.

Both disk-based hard drives and flash SSDs use the same set of LEDS.

Note – The OK/Activity LED has slightly different behavior for SSDs than for

disk-based drives. This difference is described in the table that follows the figure.

FIGURE: Hard Drive LEDs

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 239 240

Sem comentários

Fujitsu SPARC T5120 Manual do Utilizador Página 96