Fujitsu SCANPARTNER 15C Manual do Utilizador

Scanpartner 15CImage ScannerUser's ManualVersion 1.0(Doc. No. 250-0062-0)

2-62.4 ADF Output Tray (Figure 2-5)i). Hold the output paper rack some 30 degrees aslant as shown in Figure 2-5.ii). Insert the three protrusions o

2-72.5 Document LoadingFor flatbed scanning.Documents that can not be scanned using the ADF can be placed on the flatbed forscanning. Refer to Figur

2-82.6 ADF ScanningStandard paper size can be scanned automatically using the ADF. Refer to figure 2-7.i). To prevent occasional paper jam when aut

2-92.7 Connecting the Cablei). Turning the Power Off Depress the side marked “O” to turn the power off. Connect the power cable and SCSI signal cabl

2-10Figure 2-8 Scanpartner 15C Scanner Cable ConnectionFigure 2-9 Scanpartner 15C SCSI Scanner Cable Connections with MacSCSI Cable

3-13. MAINTENANCE3.1 Cleaning the ADFYour Scanner is designed to be maintenance free. However, it still needs tobe cleaned occasionally to ensure op

3-2Figure 3-1 Opening the ADF unit and Document Cover

3-33.2 Cleaning the GlassThe procedures:i). Soak a cotton swab with some isoprophy alcohol (95%).ii). Open the ADF unit and document cover as shown

4-14. TROUBLESHOOTINGThe Scanner will automatically perform a simple self-test each time it isturned on. This will help spot major system errors in t

4-2Question: Paper becomes skewed in the Scanner.Answer: a) Check the feeding roller condition; do the cleaning ifnecessary. (See Section 3.1)b) Use

iiTable of Contents1. INTRODUCTION... 1-12. INSTALLATION AND CO

4-3Question: The scanned image always comes out to be too dark.Answer: a) Use your application to modify the Gamma setting to 2.2 and1.8 for your prin

4-4Figure 4.2 ADF Paper Jam - Removing the Paper

5-15. SPECIFICATIONSAll specifications are subject to change without notice.The following can not be properly fed by ADF:❖ Paper with clip or staple

5-25.1 Scanpartner 15C SpecificationsScanner Type ❖ 1-pass colour❖ Flatbed with ADF built-inScanning Mode ❖ 30-bit colour❖ Grey Scale (256 levels

1-11. INTRODUCTIONCongratulations on your purchase of Fujitsu Scanpartner 15C Scanner.Before you install and operate the new Scanner, please take

1-2Figure 1-1 Scanner packingOutput Paper Rack

2-12. INSTALLATION AND CONNECTIONSPlease unpack the Scanner carefully, and check the contents against the checklist. Ifany items are missing or damag

2-2Figure 2-1 Removing the Shipping BracketFigure 2-2 Securing the Shipping Bracket

2-32.1.2 Refitting the Shipping Bracket:Whenever you need to move the Scanner to a new location it is advisable torefit the shipping bracket to avoid

2-4Figure 2-3 Adjusting the SCSI ID setting.SCSI ID Selector

2-52.3 ADF Paper Chute (Figure 2-4)i). Raise the right side of the paper chute to about 45 degrees.ii). Pull down the wire leg from under the paper